This jointer is loaded with features normally found only on industrial equipment. Features include: new oversized 66-inch adjustable infeed and outfeed cast-iron tables, new cast-iron, center-mounted fence assembly which provides rigid support for the workpiece, has positive stops at plus/minus 45 degrees, and Powermatic's patented "control chip" 3-knife cutterhead design which delivers the accuracy required in a 6-inch jointer. Model 54A comes complete with 1 hp, 1 phase, 115/230-volt motor, and manual switch. FEATURES
- Features Powermatic's controlled chip cutterhead
- Oversized, 66" long adjustable infeed and outfeed table (mounted on dovetailed ways)
- 38" extra-long fence
- New fine/quick adjustment lever on infeed table for precision cuts
- Enlarged sheet metal stand
- Positive fence stops
- Powerful 1 HP (TEFC) motor
- Spring loaded front guard and fixed rear guard
- 4" dust collection port
- Two way tilting fence with positive stops at 45 degrees and 90 degrees
- Conveniently mounted center fence controls
- Rabbeting ledge is built into the tables
STANDARD EQUIPMENT
- Motor
- Set of 3 high speed heat treated steel knives
- Two material push blocks
- Dust collection port
- Cutterhead guard
- Push button switch
- Standard knife setting gauge
SPECIFICATIONS
Cutting Capacity (WxD/in): 6 x 1/2
Cutterhead Speed (RPM): 4500
Number of Knives: 3
Rabbeting Capacity (in): 1/2
Table Surface (WxL/in): 7-1/4 x 66
Fence (HxL/in): 4 x 38
Blade Size (LxWxT/in): 6-1/16 x 9/8 x 1/8
Fence Tilts: 45 degrees L, 45 degrees R
Positive Stops: -45 degrees, 90 degrees, 45 degrees
Motor (TEFC): 1 HP, 1 Ph, 115/230V; Prewired 115V
Shipping Weight (lbs): 287
